|
| | DIY Atmospheric power station
|
Manual for assembling an atmospheric power plant with your own hands (DIY). Power plant power depends on the length of the receiving wire and can reach 200-300 watts.
In our time it is believed that an atmospheric power plant can not give enough energy, but this is an erroneous opinion. Meanwhile, atmospheric electricity has been used for a long time and successfully, which there is a lot of evidence (see photo above). Even in the Middle Ages, static power plants were used to power gas discharge lamps, which carried out night illumination of various structures. Now few people know about this. We again invent what we invented before us.
The use of the atmosphere as an alternative source of electric current is considered in dozens of patents and many articles. The problem is that at home it is difficult to describe the described. Run a balloon for a hundred meters or build a tall mast is too expensive and not very reliable. But you can manage and a small height.
The essence of the method is to stretch a few hundred meters of wire at a small height and to properly remove electrostatic energy from this wire. A hundred meters of wire - not too much. If you have a plot of 10 acres, its perimeter is 220 meters, which is quite enough to accommodate an atmospheric power plant.
Not every wire fits. In addition, the removal controller is very important. Common methods using an arrester are not suitable because of low efficiency. By purchasing the Guide you solve these problems and receive a 24-hour source of energy. Of course the power of the device is not kilowatts, but this is where the energy in the house is better than the dreams in the head.
| |
|
