Fuel economy
НОУ-ХАУ, УСТРОЙСТВА, КОНСТРУКЦИИ
KNOW-HOW, DEVICES, DIY
eng
Home » Automotive devices » GEET car on the water » Главная Доставка Контакты О нас   
Vortex nozzle Fog-3000 for car 7000р. Vortex nozzle Fog-3000 for car
GEET-reactor GR-3000 7000р. GEET-reactor GR-3000
DIY Manual a vortex nozzle 3000р. DIY Manual a vortex nozzle
DIY GEET-reactor plan 3000р. DIY GEET-reactor plan
Vortex Centrifugal Filter 2200р. Vortex Centrifugal Filter
GEET-plazma reactor GP-3000 19000р. GEET-plazma reactor GP-3000
DIY assembly manual GEET-plazma reactor 15000р. DIY assembly manual GEET-plazma reactor
DIY Instead of the catalyst vortex insert 1200р. DIY Instead of the catalyst vortex insert
Полезная информация
What can be put in place of catalyst What can be put in place of catalyst
Сar use water as fuel Сar use water as fuel
Popular about GEET Popular about GEET
Vortex nozzle Fog-3000 for car
Vortex nozzle Fog-3000 for car

Vortex nozzle Fog-3000 for car


Цена 7000 RUB (123 USD)
Вихревая насдка
Вихревая насдка
Вихревая насдка
Схема подключения вихревой насадки Туман
Схема подключения вихревой насадки Туман
Схема подключения вихревой насадки Туман
Размеры насадки
Размеры насадки
Размеры насадки

Car vortex nozzle Fog-3000 increases engine power and prevents overheating in dry hot weather. it may be installed on petrol, gas and diesel engines of 1-3 liters.

The nozzle is mounted on an exhaust pipe by means of clamp welding work is not required.

Increasing engine performance occurs due to feed into cylinders of a small amount of fine Jana slurry consistency similar to fog. Actually nozzle replaces expensive and not reliable systems aqueous injection. Thus it is not necessary to install on the vehicle an additional water tank. The required amount of water is taken directly from the exhaust gases.

Fuel economy is up to 20% power increase of up to 10%. After installing the nozzle can be used low-octane fuel.

The nozzle changes the sound of the engine, making it look like the work of the engine with a high-speed turbine.

It is recommended to etsya in cases where you can not install GEET-Muffler (new car warranty, there is no possibility to perform welding work, improper configuration of the exhaust system).

The device is not recommended for the preferred operation of the vehicle under conditions of high humidity.

You can also buy drawing for self-production nozzles.

Comments
2 + 7 =
отзывы
Виталий
А что делать если климат влажный?
отзывы
Админ
Можно установить совместно с GEET-реактором. Он часть воды преобразует в водород.
отзывы
Анатолий
А как ее соединять с двигателем?
отзывы
Админ
Газовой гофрированной трубкой из нержавейки. Инструкция прилагается
Page rank: 3.4 || 5 votes
vortex, nozzle, fog, car byu Original DIY or buy