Home » Automotive devices » GEET car on the water » Главная  Доставка  Контакты  О нас    
Vortex nozzle Fog-3000 for car
Vortex nozzle Fog-3000 for car

Vortex nozzle Fog-3000 for car

Схема подключения вихревой насадки Туман
Схема подключения вихревой насадки Туман
Схема подключения вихревой насадки Туман


Car vortex nozzle Fog-3000 increases engine power and prevents overheating in dry hot weather. it may be installed on petrol, gas and diesel engines of 1-3 liters.

The nozzle is mounted on an exhaust pipe by means of clamp welding work is not required.

Increasing engine performance occurs due to feed into cylinders of a small amount of fine Jana slurry consistency similar to fog. Actually nozzle replaces expensive and not reliable systems aqueous injection. Thus it is not necessary to install on the vehicle an additional water tank. The required amount of water is taken directly from the exhaust gases.

Fuel economy is up to 20% power increase of up to 10%. After installing the nozzle can be used low-octane fuel.

The nozzle changes the sound of the engine, making it look like the work of the engine with a high-speed turbine.

It is recommended to etsya in cases where you can not install GEET-Muffler (new car warranty, there is no possibility to perform welding work, improper configuration of the exhaust system).

The device is not recommended for the preferred operation of the vehicle under conditions of high humidity.

You can also buy drawing for self-production nozzles.

2 + 7 =
отзывы
Виталий
А что делать если климат влажный?
отзывы
Админ
Можно установить совместно с GEET-реактором. Он часть воды преобразует в водород.
отзывы
Анатолий
А как ее соединять с двигателем?
отзывы
Админ
Газовой гофрированной трубкой из нержавейки. Инструкция прилагается
DIY Manual a vortex nozzleDIY Manual a vortex nozzle

Полезная информация


Original DIY or buy